A Computer hardware and components forum. ComputerBanter.com

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » ComputerBanter.com forum » Motherboards
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Abit Motherboards Forum Tools Search this Forum Feed Icon
  Thread Reverse Sort Order / Thread Starter Last Post Replies Views
WD 74GB RAPTOR 16MB CACHE INCOMPATIBLE, Previous generation with8MB of cache work fine. by Justin Piszcz
I have five A-Bit IC7-G motherboards, each of which is equipped with 4 SATA ports, 2 are on the Intel ICH5 controller 2 are on a separate SiI 3112 chipset My...
December 25th 06 12:28 AM
by Justin Piszcz Go to last post
0 1,193
'CPU is unworkable or has been changed' by Ben Hardy
Hi I've got a Abit IS7-E2 mobo with a Celeron D 325 2.35GHz CPU I'm intermittently getting the following message at boot up: 'CPU is unworkable or has been...
September 28th 06 06:47 PM
by Ben Hardy Go to last post
2 654
0.5sec delay in S/PDIF output stream causes loss of audio by Agamemnon
I am using an ABIT IC-7G motherboard with an AC7 compatible audio chipset by Realtek which is connected to my AV amp via an S/PDIF optical cable. I have all...
January 21st 05 12:23 AM
by Agamemnon Go to last post
7 607
1 Gig P3 on SE6 MB not working by Matt
I have a SE6 V1 MB that has been running a 933 P3 ok, but not able to use a 1G P3, from the number on the Intel site the and the Abit latest bios this should...
September 11th 03 05:27 AM
by D & B Go to last post
3 718
1 how come my pc3200 ram is running at 333mhz? i have a nf7-s with a 2500+ cpu and it runs at 333...which setting do i make ram run at 400? by louisk
1 how come my pc3200 ram is running at 333mhz? i have a nf7-s with a 2500+ cpu and it runs at 333...which setting do i make ram run at 400?
April 19th 04 10:35 AM
by Wes Newell Go to last post
1 453
1.4GHz PIII-S Tualatins on a VP6!! HELP!!! by Rohan Beckles
Hello -- I don't normally cross-post, but in this case I'm quite desperate for help (please see sig for spec). I have recently purchased two Tualatin...
July 6th 04 02:39 PM
by Homie Go to last post
9 474
2 hdd setup by mumphry
Hello, i am running an NF7-S ver 2.0 with 2 hard drives on first ide channel and one dvd and one cd/r on the second channel. both hard drives are a lot slower...
May 8th 05 08:37 PM
by MikeE Go to last post
2 650
233MHz+ FSB settings dont work on KV8-Max3!? by Matt Simis
Hi, Got a KV8-Max3 a couple of days ago and am having a few problems. Firstly, my KingMax PC3500 ram doesnt work at even DDR400 speeds in it. I put in my...
March 4th 04 01:34 AM
by Andrew Diederich Go to last post
1 453
366 Garmin GPS 36664 by Morales
======================================= Get A GPS Today At A Low Price!! http://www.GPSTakesYou.com ======================================= GPS...
July 16th 08 10:27 PM
by Morales Go to last post
0 2,262
400 Mhz FSB micro on 333 FSB MB? by skyhydro
Would an AMD XP 400mhz fsb 3200+ work on KD7-Raid which can only support up to 333 Mhz FSB micros? I'm thinking of buying a faster 400mhz micro today so I...
July 19th 04 05:32 AM
by Wes Newell Go to last post
1 317
48bit by herbzee
I have an ABIT IT7; how can I find out if it has 48 bit addressing for a larger hdd-eg 200gig?
January 15th 04 08:54 PM
by S.Heenan Go to last post
1 439
516570473687 money 516570473687 by RASCH
TURN TWELVE DOLLARS INTO THOUSANDS EASILY AND HONESTLY!!!! THIS MESSAGE WILL CHANGE YOUR LIFE FOREVER!!!! --- I found a message similar to this one on a...
February 15th 04 03:57 AM
by RASCH Go to last post
0 470
537761574523 money 537761574523 by RASCH
TURN TWELVE DOLLARS INTO THOUSANDS EASILY AND HONESTLY!!!! THIS MESSAGE WILL CHANGE YOUR LIFE FOREVER!!!! --- I found a message similar to this one on a...
February 15th 04 03:57 AM
by RASCH Go to last post
0 460
August 20th 04 09:40 PM
by Go to last post
0 645
64K page mode ? by Richard Sharp
Hello, My abit KT7 MB has probably a later BIOS than is used for the Users Manual. Under the setup menu there is an option to enable what I remember said 64K...
August 12th 04 10:42 PM
by Wes Newell Go to last post
2 254
6in1 and abit vh6T by PeptoP
I bought this cheap IC card reader... I burnt up the first one since Abit puts their header pins backward on this board. But I bought another (one 8 bucks)...
August 8th 03 10:26 PM
by PeptoP Go to last post
0 582
8X AGP in 1X AGP MOTHERBOARD ? by John F
I've got an old BH6 v1.0. I want to upgrade my graphics card. Will an 8X AGP graphics card (like GeForce 5700 Ultra) be OK in it? I think the BH6 is only 1X...
January 11th 04 11:57 PM
by NuT CrAcKeR Go to last post
2 314
9.6 De-Assert CPU core voltage by Anthony J. Elcocks
Hi, I am new to posting AND building a pc, so please be gentle ! I bought an Abit AA8 Duramax mobo. Added a P4 3.4 CPU Gigabyte 6600GT PCIx video card 1GB...
February 8th 05 03:19 PM
by geiroh Go to last post
2 467
a problem with ABIT SE6 by morpheus276
Hi guys, i have a GREAT problem. I own a ABIT SE6 motherboard with Celeron 600MHz processor. Two weeks ago, it started to give me this problem: when i start...
October 31st 05 09:36 PM
by Wes Newell Go to last post
2 736
a problem with ABIT SE6 by morpheus276
Hi guys, i have a GREAT problem. I own a ABIT SE6 motherboard with Celeron 600MHz processor. Two weeks ago, it started to give me this problem: when i start...
October 31st 05 09:01 PM
by morpheus276 Go to last post
0 774
Post New Thread


Display Options
Showing threads 1 to 20 of 902
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 09:53 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 ComputerBanter.com.
The comments are property of their posters.