|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Disk replacement for HPz210 small form factor
On 12/5/2017 10:36 AM, John McGaw wrote:
On 12/5/2017 12:12 AM, t wrote:
On 12/4/2017 10:26 AM, John McGaw wrote:
On 12/3/2017 9:36 PM, t wrote:
We got two HPZ210 small form factor
computers from another area, but they don't have a hard disk as well
as the data and power cables which connect to them.
1. Can an SSD like
work for the HPz210 computers if I get the following SATA and power
2. Or, would I need any other cables also?
Any advice would be appreciated.
The drive should work fine since it is a bog standard SATA interface --
no 'micro' adapter necessary, just a suitable high-quality SATA cable
rated for 6gb/s. Both the motherboard and the proposed drive are rated
for that speed. As for the power, it seems highly unlikely that there
isn't already a SATA power connector in place but the 'manual' is vague
to say the least. Have you looked? As Paul wrote, having a converter
from Molex to SATA power won't hurt you since they are cheap but there
is no use in buying something you'll likely never need (this written by
someone who has thrown out literally bushels of weird old obsolete
cables and adapters over the years).
If something like this
works I can get it
As for mounting the drive, there are physical adapters to fit the 2.5"
drives into 3.5" spaces but I've had as much success using a bit of
double-stick foam tape -- SSD drives weigh next to nothing and are not
I appreciate your advice.
The cable you linked is for a 'slim-line' drive. The SSD you mentioned
first is a standard drive. The two are not necessarily compatible and
are meant for entirely different purposes. What you need is a standard
full-size SATA III cable long enough to reach from the motherboard
connector to the drive, wherever you mean to install it. As for power, I
still think that your computer probably has the appropriate 15-pin SATA
power connector on the power supply harness. Have you looked to see? If
your computer doesn't have the connector then you will need an adapter
to go from an old-school AMP/Molex 4-pin to a standard SATA 15-pin in
addition to the SATA data cable.
Since you keep referencing Amazon, try going there and searching for
'SATA III cable'. You will get a couple of pages full of suitable
candidates. You'll need to figure out if you need straight or
right-angle versions depending on how you will mounting the drive. There
are even some power adapters showing up in the search.
I appreciate your advice and help. Your advice was very helpful. I found
the SATA cables.
Have a good holiday.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Small Form Factor Recommendation||Jack||Gigbyte Motherboards||8||October 27th 05 09:50 PM|
|Small Form Factor Recommendation||Jack||Asus Motherboards||8||October 27th 05 09:50 PM|
|How Buy SMall Form Factor PC||[email protected]||Homebuilt PC's||0||November 29th 04 10:37 PM|
|Biostar small form factor||Eddy||General||1||November 16th 04 04:20 PM|
|Small form factor computers||[email protected]||Homebuilt PC's||11||June 3rd 04 08:38 PM|