|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
"The ROM PCI IRQ routing table appears to be faulty!!"
ROM PCI IRQ routing table Tests....
ROM IRQ routing table found at F000h:2B20h
Table Version 1.0 - OK
Table size 240 bytes - OK
Table Checksum 84h - OK
PCI Interrupt Router: 82801BA LPC Interface (ICH2 B4 step)
IRQ's dedicated to PCI : None
Error: connectivity mismatches for link value 63:
Bus=0 Device=31 Pin=INTA# Map=3,4,5,6,7,9,10,11,12,14,15
Bus=2 Device= 1 Pin=INTA# Map=9,10,11
The ROM PCI IRQ routing table appears to be faulty!!
Unsure of what the message about the faulty routing table means.
It means that in two different portions of the table, written by whoever
compiled your machine's firmware, the same PCI INT line is described as
mappable to two different sets of ISA IRQs.
|Thread||Thread Starter||Forum||Replies||Last Post|
|USB bootable maker: Diff between "HP Drive Key Boot Utility" and "HP USB Disk Storage Format Tool"?||Jason Stacy||Storage (alt)||1||April 21st 09 01:14 AM|
|"true life" vs. "anti-glare" of Vostro 1500: What are the brightness & contrast ratios???||Thomas G. Marshall||Dell Computers||1||April 11th 08 10:47 PM|
|Downside of changing "Max frames to render ahead"/"Prerender Limit" to 1/0?||Jeremy Reaban||Nvidia Videocards||2||March 31st 06 04:24 AM|
|A new director in an existing Brocade fabric and "Port Based Routing Policy"||[email protected]||Storage & Hardrives||0||November 21st 05 09:38 AM|